ISSN 1897-8649 (Print)
eISSN 2080-2145 (Online)
completely current issue
avaliable on-line
Editorial Board
Editorial Office
Industrial Research Institute for Automation and Measurements "PIAP"
building 4 , room 206
Al. Jerozolimskie 202
02-486 Warsaw
POLAND
tel.: +48-22-8740-109
fax : +48-22-8740-209
|
|
ISSUE 04/2009
[click here for full electronic issue]
SPECIAL ISSUE SECTION
Inter-Academia 2009
Guest Editor:
Ryszard Jabłoński
|
|
07
EDITORIAL
R. Jabłoński
|
|
09
Femtosecond photonics for three-dimensional high density optical data storage
Y. Kawata, M. Tsuji, et al.
|
|
12
Elevated giant magneto-impedance in amorphous metallical Co-dased alloys
L.V. Poperenko, D.Yu. Manko
|
|
15
An Xps study of RF sputtered Ti1-xFexO2-δ thin films
D. Luca, R. Apetrei, et al.
|
|
18
The assessment of "Jatropha" as raw material for BDF
S. Matsuda, B. Rudyanto, et al.
|
|
21
Investigation into electrochemical discharge machining of micro holes
L. Kudła
|
|
25
An introduction of high-precise 3D measurement system and its applications
T. Hashimoto, M. Kaneko, et al.
|
|
29
New optical equipment in 3D surface measuring
K. Wenzel, Á. Antal, et al.
|
|
33
Dynamics of laser-induced melting and modification of the surface of semiconductors by nanosecond laser pulses
V. Gnatyuk, T. Aoki, et al.
|
|
37
Radius measurement of cylindrical surfaces based on analyzing the interference pattern obtained by scanning the surface with focused laser beam
R. Jabłoński, J. Mąkowski
|
|
41
ISpace – a tool for improving the quality of life
A.R. Varkonyi-Koczy, A.A. Tóth
|
|
46
Simulation of Coulomb-coupled protein-based logic
B. Rakos
|
|
49
Seebeck coefficient measurement by Kelvin-Probe force microscopy
H. Ikeda, F. Salleh, et al.
|
|
52
Single-electron transport characteristics in quantum dot arrays due to Ionized dopants
D. Moraru, M. Ligowski, et al.
|
|
55
Sol-gel glassy antireflection GeO2 – SiO2 – Ag – Re films for solar cells and IR-devices
D. Kovalenko, V. Gaishun, et al.
|
|
58
Multi-scale simulation of hybrid silicon nano-electromechanical (NEM) information systems
H. Mizuta, M.A.G. Ramirez, et al.
|
|
62
Nanohills in SiGe/Si structure formed by laser radiation
A. Medvid, P. Onufrijev, et al.
|
|
65
Effect of substrate temperature on the crystal properties of LiMn2O4 films prepared by RF magnetron sputtering
M. Isai, K. Nakamura, et al.
|
|
69
Dye-sensitized solar cells based on SnO2 nanorod and surface treatment with Mg(II) film
J. Bai, K. Murakami
|
|
72
Analysis of current noise in MOSFET-based charge-transfer device
H. Inokawa, V. Singh, et al.
|
|
76
Epileptic burst measurement using microelectrodes equipped on a cryogenic microprobe for minimally invasive brain surgery of intractable epilepsy treatment
T. Yamakawa, T. Yamakawa, et al.
|
|
80
R&D of novel medicinal materials for curing cancer: sugar modified Gd-DTPA MRI contrast agents and Phospha Sugar Anti-cancer agents
J. Yamashita, M. Yamashita, et al.
|
|
84
Analyses of the genes involved in disease development to construct disease-resistant plants by genetic engineering
S. Tsuyumu, H. Hirata
|
|
87
Powder injection moulding of micro parts
D. Biało, A. Skalski
|
|
91
Influence of synthesis conditions on the properties of FexCoyOz- nanoparticles in SiO2 sol-gel film
V.V. Sidsky, V.E. Gaishun, et al.
|
|
93
Low-range tilt sensing with MEMS accelerometers
S. Łuczak, D. Kołodziej
|
|
96
Testing of the three axis magnetometers for measurements of the earth magnetic field
R. Szewczyk, J. Salach, et al.
|
|
99
Fabrication of photonic crystal structures by laser lithography
V. Mizeikis, K.K. Seet, et al.
|
|
102
Plasmonic nano-imaging with metallic nanolens
A. Ono
|
|
105
Overhauser effect and anisotropy of electron spin g-factor in GaAs / AlGaAs quantum wells
T. Ito, P. Verma, et al.
|
|
108
Study of low temperature inactivation of spores using microwave excited air plasma
M. Nagatsu, M.K. Singh, et al.
|
|
112
ZnO films: properties determined by electronic microscopy and ellipsometry
M. Rakov, L. Poperenko, et al.
|
|
115
Tribological properties of multilayered vacuum coating
A. Rogachou, A. Popov, et al.
|
|
118
Tools and technique of monitoring resource distribution for design simulation of organization of information processing
O.M. Demidenko
|
|
121
Application of sol-gel process for preparation of functional materials
V.E. Gaishun, O.M. Demidenko, et al.
|
|
124
The growth and properties of ZnO films grown using PA-MOVPE with DMZn and N2O
T. Nakano, K. Nishimoto, et al.
|
|
127
Mechanism of nanostructure formation on a surface of CdZnTe crystal by laser irradiation
A. Medvid', A. Mychko, et al.
|
|
130
Detection of individual dopants in singe-electron devices - a study by KFM observation and simulation
M. Ligowski, D. Moraru, et al.
|
|
134
Impurity-concentration dependence of seebeck coefficient in silicon-on-insulator layers
M.F. Mohd Salleh, K. Asai, et al.
|
|
137
CdTe X-ray imaging device using vertical thin film field emitter array
Y. Tsunekawa, M. Nakagawa, et al.
|
|
140
Formation of “black silicon” on a surface of Ni/Si structure by Nd:YAG laser radiation
A. Medvid', A. Karabko, et al.
|
|
143
High speed signal processing for photon counting X-ray detection
B. Shinomiya, A. Koike, et al.
|
|
147
Thermionic vacuum arc diagnostic using emissive probe
V. Tiron, C. Aniculaesei, et al.
|
|
150
Investigation of low temperature plasma capabilities to modify the structure and function of bio-polymers
J. Motrescu, T. Hara, et al.
|
|
153
Testing of carbon fibers as tool electrodes in micro electrical discharge machining
L. Kudła, A. Trych
|
|
157
Quintet-gated FEA to form crossover beam
T. Tagami, M. Takeda, et al.
|
|
160
Measurements of plasma diffusion coefficient in Pilot-PSI device using Katsumata probe
M.L. Solomon, I. Mihaila, et al.
|
|
163
Growth and application of ultra-long multi-walled carbon nanotube
S. Sayaka, M. Okada, et al.
|
|
166
Influence of powerful laser radiation on formation of pores in Si by electrochemical etching
A. Medvid, P. Onufrijevs, et al.
|
|
169
Probe radius correction methods – review and comparison of existing methods
A. Rak, A. Woźniak
|
|
172
One dimensional kinetic model of CMM passive scanning probes
G. Krajewski, A. Woźniak
|
|
175
Design of multi-layer sputter-deposited anode to reduce catalyst loading for liquid DMFC
H. Saito, T. Nakashima, et al.
|
|
179
Numerical simulation of blood flow and cholesterol distribution for middle cerebral artery with coarctation
M. Naito, K. Mizoguchi, et al.
|
|
184
A versatile model for music creation utilizing tension states
H. Ruuska, Y. Takebayashi
|
|
187
A New Man-Machine Interface for iSpace applications
A.A. Toth, A.R. Várkonyi-Kóczy
|
|
191
Synthesis and evaluation of novel MRI contrast agents of chemically modified Gd-DTPA complexes with sugars
M. Sugiyama, M. Yamashita, et al.
|
|
195
The design of an insulin pump - concept of closing the loop
H. Hawłas, K. Lewenstein
|
|
199
Acoustic waves in ceramics with the electro induced anisotropy
S.A. Khakhomov, S.D. Barsukov, et al.
|
|
202
Reduction of random telegraph signal (RTS) noise in CMOS image sensors using histogram analysis
M.A. Mustafa, S. Itoh, et al.
|
|
204
Linearized settling error calibration for a pipeline A/D converter using non-slewing amplifiers
S.-W. Jun, K. Yasutomi, et al.
|
|
207
Effect of maximum interaction of circularly polarized electromagnetic waves with the molecule of DNA
A.P. Balmakov, I.V. Semchenko, et al.
|
|
210
Irreversible blocking of polar excitations on frog sciatic nerve using semiconductor pulse laser irradiation
Y. Hirayama, T. Yamakawa, et al.
|
|
213
Color calibration method providing uniform distribution of color difference throughout the whole vision gamut
M. Kretkowski, Y. Shimodaira, et al.
|
|
217
Simplified calibration methods for the measuring of LCD monitor charasteristics
A. Molnar, K. Samu
|
|
220
Introduction of three-dimensional measurement technologies developed and applied in Suzuki Motor Corporation
Y. Yamage, T. Aoki, et al.
|
|
224
Application of dielectric layers in surface plasmon resonance sensors
S. Kurlov, T. Lebyedyeva, et al.
|
|
228
Small batch size robot programming with human in the loop
B. Takarics, G. Sziebig, et al.
|
|
|
DEPARTMENTS
|
|
232
IN THE SPOTLIGHT
|
|
234
EVENTS
|
|
|
|
Editor-in-Chief
Janusz Kacprzyk
(Systems Research Institute, Polish Academy of Sciences, PIAP, POLAND)
Co-Editors
- Dimitar Filev (Research & Advenced Engineering, Ford Motor Company, USA)
- Kaoru Hirota (Interdisciplinary Graduate School of Science and Engineering, Tokyo Institute of Technology)
- Witold Pedrycz (ECERF, University of Alberta, Canada)
- Roman Szewczyk (PIAP, Warsaw University of Technology)
Executive Editor
Anna Ładan
Associate Editors
Mariusz Andrzejczak
Katarzyna Rzeplińska-Rykała
Web editor
Tomasz Kobyliński
|
PIAP Industrial Research Institute
